Hi,
I would like to be able to reset fuses on my ATMEGA2560 Arduino R3 board?
Can any one share ideas on how this can be accomplished with the HV Rescue Shield 2?
Thanks,
Paul K.
How can I adapt the HV Rescue Shield for an ATMEGA2560
Re: How can I adapt the HV Rescue Shield for an ATMEGA2560
That's an interesting idea but it sounds pretty challenging. The ATMEGA is soldered to the Arduino so it can't easily be removed for programming. You could try wiring individual signals from the Rescue Shield to the ATMEGA, but the Rescue Shield needs to cycle power to the AVR during programming, and that would be hard to do with the rest of the Arduino connected!
Jeff Keyzer
http://mightyohm.com
http://mightyohm.com
Re: How can I adapt the HV Rescue Shield for an ATMEGA2560
please can you show me wirings for an atmega 2560,
it is a prototype board and i removed all components,
i have only 2560 soldered on the board and all free pins.
thank you.
it is a prototype board and i removed all components,
i have only 2560 soldered on the board and all free pins.
thank you.
Re: How can I adapt the HV Rescue Shield for an ATMEGA2560
Which version of the kit are you using?
Jeff Keyzer
http://mightyohm.com
http://mightyohm.com