Re: OpenWRT vs DD-WRT
Posted: Mon Jan 13, 2014 6:53 am
I used to have option 1 in my setup. Quite useful at the time.
I have wireless working with psk2. No problem (other than lousy wireless on my ISPs router )-: )
If I remember correctly, I can just connect wired Ethernet to the wan port when wireless is off. However, to connect to it from the wan side, you'd have to add a rule to the firewall to allow that. I think that in my configuration you could do without that by using a normal lan-port, but I'm not sure.
Here is my config
Those mpd errors look to be expected, if you don't have a soundcard pluged in.
I have wireless working with psk2. No problem (other than lousy wireless on my ISPs router )-: )
If I remember correctly, I can just connect wired Ethernet to the wan port when wireless is off. However, to connect to it from the wan side, you'd have to add a rule to the firewall to allow that. I think that in my configuration you could do without that by using a normal lan-port, but I'm not sure.
Here is my config
Code: Select all
root@OpenWrt:/# cat /etc/config/wireless
config wifi-device wl0
option type broadcom
# option channel 11
# REMOVE THIS LINE TO ENABLE WIFI:
# option disabled 1
config wifi-iface
option device wl0
option network lan
option mode sta
option ssid Buurman
option encryption psk2
option key aGFidXVybUHq
root@OpenWrt:/# cat /etc/config/network
#### VLAN configuration
config switch eth0
option vlan0 "1 2 3 4 5*"
option vlan1 "0 5"
#### Loopback configuration
config interface loopback
option ifname "lo"
option proto static
option ipaddr 127.0.0.1
option netmask 255.0.0.0
#### LAN configuration
config interface lan
option type bridge
option ifname "eth0.0"
option proto dhcp
#option proto static
#option ipaddr 192.168.16.1
#option netmask 255.255.255.0
#### WAN configuration
config interface wan
option ifname "eth0.1"
option proto dhcp
Those mpd errors look to be expected, if you don't have a soundcard pluged in.