I'm having the beep problem. My dmesg output is
- Code: Select all
usb-ohci.c: USB OHCI at membase 0xb8003000, IRQ 6
usb-ohci.c: usb-00:03.0, PCI device 14e4:471a
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
hub.c: new USB device 00:03.0-1, assigned address 2
usb.c: USB device 2 (vend/prod 0x1130/0xf211) is not claimed by any active driver.
device wl0 entered promiscuous mode
wl0: attempt to add interface with same source address.
br-lan: port 2(wl0) entering learning state
br-lan: port 2(wl0) entering forwarding state
br-lan: topology change detected, propagating
usb.c: registered new driver audio
usbaudio: device 2 audiocontrol interface 0 has 1 input and 1 output AudioStreaming interfaces
usbaudio: device 2 interface 2 altsetting 1 channels 1 framesize 2 configured
usbaudio: valid input sample rate 24000
usbaudio: device 2 interface 2 altsetting 1: format 0x00000010 sratelo 24000 sratehi 24000 attributes 0x00
usbaudio: device 2 interface 1 altsetting 0 does not have an endpoint
usbaudio: device 2 interface 1 altsetting 1 channels 2 framesize 2 configured
usbaudio: valid output sample rate 48000
usbaudio: device 2 interface 1 altsetting 1: format 0x01000010 sratelo 48000 sratehi 48000 attributes 0x00
usbaudio: registered dsp 14,3
usbaudio: constructing mixer for Terminal 3 type 0x0301
usbaudio: registered mixer 14,0
usbaudio: constructing mixer for Terminal 6 type 0x0101
usbaudio: registered mixer 14,16
usb_audio_parsecontrol: usb_audio_state at 80c1aee0
audio.c: v1.0.0:USB Audio Class driver
and I have the mpd.conf set thusly:
- Code: Select all
# An example of an OSS output:
name "My OSS Device"
device "/dev/sound/dsp" # optional
format "44100:16:2" # optional
Am I correct in believing that my problem might be the output frequency mismatch? It looks like dmesg is saying my device supports 48000 and have the format set to 44100 in mpd.conf - am I on the right track?
Thanks for the help guys.