OK, I managed to nuke my low-end temp. controller (on/off setup.) I'm looking for the resistor values for the SSR terminals (4 and 5) on my output diagram. (The fried resistors were located at the burn mark.) Also the resistor shown beyond in the picture below also seems fried (zero resistance value on my multimeter) (terminal 2 on the mains input), but I have the color bands to tell it's value.
I hope that none of the other components on the board are bad, but if that's the case, I'll just buy another unit. Can anyone help with the resistor value(s)?
Discussion about events, resources, or any topic not related to one of the project forums below.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests