CDV-700 calibration question.

Discussion about events, resources, or any topic not related to one of the project forums below.
XOIIO
Posts: 1
Joined: Mon Jul 14, 2014 5:52 pm

CDV-700 calibration question.

Postby XOIIO » Mon Jul 14, 2014 5:58 pm

Hello all, unsure if this is a good place to discuss this or not, but I can't find many Geiger counter forums.

I recently got myself a CDV 700, and while I want to get it professionally calibrated it's a bit expensive at this time (a tad over $100, just $35 less than I paid not including shipping).

Anyways, I have heard that the test source is either supposed to measure at 2 exactly, or between two and 3, however this one reads up to 4 easily, and can even max out the meter (all on the 10x range btw) if I position it right.

Now, if anything it should read lower due to the half life of depleted uranium, no?

Just wondering if I should "calibrate" it so that it reads roughly 2 or so, or if it might be fine, and they used the alternative to depleted uranium and somehow it has gained radioactivity?

Anyways, just hoping for it to be roughly accurate till I have the spare cash to get it calibrated. It is understandable that it is out of cal though, since the last calibration was in 1984 :)

User avatar
JoshuaOa
Posts: 2
Joined: Sat May 14, 2016 8:38 pm
Location: Bosnia Herzegovina
Contact:

CDV 700 calibration question

Postby JoshuaOa » Thu Jul 21, 2016 4:26 pm

Oh, forgot to mention by following the above noted instructions the midrange best number for calibration was 10 this time first photo - for the above pictures. The first time I did it the midrange best number was -8


Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 6 guests